How to Assemble a Stun Gun
(0 votes, average: 0.00 out of 5)You need to be a registered member to rate this post.
Loading ...
Stun guns and tasers are non-lethal electrical piece of equipment utilized as a self-defense weapon created to halt or incapacitate an attacker by dispensing a high voltage jolt of electrical power to his/her body.
The shock causes the attacker’s muscle tissue to stop and he/she will fall and end up incapacitated for a several moments. This gives the stun gun user time to break free from the attacker.
Stun Guns are can be obtained in the U. S. if you are more than the age of eighteen and can be transported in the majority of states legally, except for Illinois, Hawaii, Massachusetts, Michigan, New Jersey, New York, Rhode Island and several metropolitan areas which include Annapolis, MD, Baltimore, MD, District of Columbia and Philadelphia.
It’s very dangerous to trust your wellbeing to a selfmade apparatus, consequently it’s not advised to assemble your own stun gun. Nevertheless, the following are guidelines to assemble a stun gun using a throw away camera that will produce less than 1/4 of the voltage of a professionally made stun gun.
Simple steps to assemble a stun gun:
1. Utilizing a screw driver open up the back of a throw away camera.
2. Remove the battery power from the camera.
3. Find the miniature light bulb that is utilized as the camera’s flash.
4. Remove the camera flash to the full extension so that the wires connecting it will allow. If the wires are soldered in position cut them with the wire shears. If the wires are wrapped around contact points, then un-wrap them cautiously.
5. Cut two 3-4 inches equal lengths of copper wire.
6. Wrap each wire to the wires that was connected to the flash bulb.
7. Apply some soldering wire to the joints and melt it into place with the soldering iron. This will create longer wires protruding from the camera. These wires should never touch, but should be within a few inches of each other at all times. Thicker and stiffer sheathed copper wiring will make it easier to accomplish this. Place this aside for the moment.
8. Then, cut the plastic cover of a five star binder free using scissors keeping it in a single piece if possible.
9. Place the thick plastic coating on the camera in order to sheath the exposed circuitry and cut holes for the flash and shutter buttons on the camera, then place the batteries back in place.
10. Glue the covers in place. The unit will now look like a thick appointment planner with two stiff wires sticking out of the top.
11. Pressing the shutter button will cause sparks, which can be used as a stun gun.
As explained above, constructing your own stun gun is not advisable due to the fact you can very easily hurt yourself and it may not be trustworthy. Purchasing a stun gun is preferred because they are very affordable, constructed carefully, and will not injure you if utilized properly.
Written by Dexter Johnson. You can find out more information about stun guns and the Taser m26c at Stunster.com.
convert this post to pdf.
Convert This Post To PDF
Loading ...